The microstructure evolution of a 10Cr ferritic/martensitic heat-resistant steel during creep at 600℃ was investigated in this work. Creep tests demonstrated that the 10Cr steel had higher creep strength than conventional ASME-P92 steel at 600℃. The rnicrostructure after creep was studied by transmission electron microscopy, scanning electron microscopy and electron probe microanalysis. It was revealed that the martensitic laths were coarsened with time and eventually developed into subgrains after 8354 h. Laves phase was observed to grow and cluster along the prior austenite grain boundaries during creep and caused the fluctuation of solution and precipitation strengthening effects, which was responsible for the two slope changes on the creep rupture strength vs rupture time curve. It was also revealed that the microstructure evolution could be accelerated by stress, which resulted in the lower hardness in the deformed part of the creep specimen, compared with the aging part.
Mn distribution and austenite morphology at the early stage of intercritical annealing of 5Mn steel were investigated. It was experimentally demonstrated that a newly formed 20 nm-thick austenite was formed without the partitioning of Mn. The elemental analysis confirmed that the growth of austenite should be controlled by the diffusion of C prior to the diffusion of Mn at a low heating rate. The austenite growth started under negligible-partitioning local equilibrium mode and then switched to partitioning local equilibrium mode. Mn segregation at the γ/α interface suggested that the collector plate mechanism was the essential way of Mn partitioning at the early stage of austenite growth.
Xi-nan LUOXiao-yan ZHONGHai-wen LUOHui-hua ZHOUCun-yu WANGJie SHI
