Solar cells that combine single-crystalline silicon （Si） with graphene （G） have been widely researched in order to develop next-generation photovoltaic devices. However, the power conversion efficiency （PCE） of G/Si solar cell without chemical doping is commonly low due to the relatively high resistance of graphene. In this work, through combining graphene with carbon nanotube （CNT） networks, we fabricated three kinds of hybrid nanocarbon film/Si heterojunction solar cells in order to increase the PCE of the graphene based Si solar cell. We investigated the characteristics of different nanocarbon film/Si solar cells and found that their performance depends on the heterojunctions. Specifically, a doping-free G-CNT/Si solar cell demonstrated a high PCE of 7.9%, which is nearly equal to the combined value of two individuals （G/Si and CNT/Si）. This high efficiency is attributed to the synergistic effect of graphene and CNTs, and can be further increased to 9.1% after applying a PMMA antireflection coating. This study provides a potential way to further improve the Si based heterojunction solar cells.
In this work, we have presented a freestanding and flexible CNT-based film with sheet resistance of 60 ？/ and transmittance of 82% treated by nitric acid and chloroauric acid in sequence. Based on modified CNT film as a transparent electrode, we have demonstrated an ultrathin, flexible organic solar cell（OSC） fabricated on 2.5-μm PET substrate. The efficiency of OSC, combined with a composite film of poly（3-hexylthiophene）（P3HT） and phenyl-C61 butyric acid methyl ester（PCBM） as an active layer and with a thin layer of methanol soluble biuret inserted between the photoactive layer and the cathode, can be up to 2.74% which is approximate to that of the reference solar cell fabricated with ITO-coated glass（2.93%）. Incorporating the as-fabricated ITO-free OSC with pre-stretched elastomer, 50% compressive deformation can apply to the solar cells. The results show that the as-prepared CNT-based hybrid film with outstanding electrical and optical properties could serve as a promising transparent electrode for low cost, flexible and stretchable OSCs, which will broaden the applications of OSC and generate more solar power than it now does.
Continuous CNT fibers have been directly fabricated in a speed of 50 m/h-400 m/h,based on an improved chemical vapor deposition method.As-prepared fibers are further post-treated by acid.According to the SEM images and Raman spectra,the acid treatment results in the compaction and surface modification of the CNTs in fibers,which are beneficial for the electron and load transfer.Compared to the HNO3 treatment,HClSO_3 or H_2SO_4 treatment is more effective for the improvement of the fibers＇ properties.After HCISO_3 treatment for 2 h,the fibers＇ strength and electrical conductivity reach up to-2 GPa and-4.3 MS/m,which are promoted by-200%and almost one order of magnitude than those without acid treatment,respectively.The load-bearing status of the CNT fibers are analyzed based on the downshifts of the G＇ band and the strain transfer factor of the fibers under tension.The results reveal that acid treatment could greatly enhance the load transfer and inter-bundle strength.With the HCISO3 treatment,the strain transfer factor is enhanced from-3.9%to-53.6%.
Bridged strips consisting of carbon nanotubes and poly（vinylidene fluoride） are developed, which exhibit notable deflection in response to very low driven voltages（ 1 V）, because of both the excellent conductivity of the unique carbon nanotube film and the powerful thermal expansion capability of the polymer. The actuators demonstrate periodic vibrations motivated by the alternating signals. The amplitude of displacement is dependent not only on the driven voltage but also on the applied frequency. The mechanism of actuation is confirmed to be the thermal power induced by the electrical heating. By accelerating the dissipation of heat, the vibration response at higher frequencies can be significantly enhanced.The useful locomotion shows great promise in potential applications such as miniature smart devices and micro power generators.
We provide an effective method to investigate the field gradient effect in nanoconfined plasmon-matter interaction.Aligned ultralong SWNTs without defects were grown on marked substrates, followed by assembling gold nanoparticle clusters around individual nanotubes. The Raman scattering behavior of a nanotube placed in an atomic scale nanogap between adjacent nanoparticles was studied. In addition to the expected plasmon-induced Raman enhancement up to 103,the defect-free D-mode of an individual SWNT induced by gradient field is found for the first time. When the light is confined at atomic scale, gradient field Raman scattering becomes significant and dipole-forbidden phonon modes can be activated by quadrupole Raman tensor variation, indicating breakdown of the Raman selection rules.
Lithium–sulfur（Li–S） batteries have received more and more attention because of higher specific capacity and energy density of sulfur than current lithium–ion batteries. However, the low electrical conductivity of sulfur and its discharge product, and also the high dissolution of polysulfides restrict the Li–S battery practical applications. To improve their performances, in this work, we fabricate a novel free-standing, curled and partially reduced graphene oxide（CPrGO for short） network and combine it with sulfur to form a CPrGO–S composite as a cathode for Li–S battery. With sulfur content of 60 wt%, the free-standing CPrGO–S composite network delievers an initial capacity of 988.9 m Ah·g^（-1）. After 200 cycles,it shows a stable capacity of 841.4 m Ah·g^（-1） at 0.2 C, retaining about 85% of the initial value. The high electrochemical performance demonstrates that the CPrGO–S network has great potential applications in energy storage system. Such improved properties can be ascribed to the unique free-standing and continous CPrGO–S network which has high specific surface area and good electrical conductivity. In addition, oxygen-containing groups on the partially reduced graphene oxide are beneficial to preventing the polysulfides from dissolving into electrolyte and can mitigate the ＂shuttle effect＂.
The electronic structures and optical properties of graphyne consisting of sp-and sp 2-hybridized carbon atoms are studied using first-principles calculations.A tight-binding model of the 2p z orbitals are proposed to describe the electronic bands near the Fermi level.The results show that the natural band gap of graphyne originates from the inhomogeneous bindings between differently-hybridized carbon atoms.The interlayer interactions of bulk graphyne narrow the band gap to 0.16 eV and result in redshift of the optical spectral peaks as compared to single-layered graphyne.
HE XiuJie TAN Jie BU HongXia ZHANG HongYu ZHAO MingWen
We use a modified Becke-Johnson exchange plus a local density approximation correlation potential within the density functional theory to investigate the electronic structures of Hg1-xCdxTe and In1-xGaxAs with x being 0, 0.25, 0.5, 0.75, and 1. For both of the two series, our calculated energy gaps and dielectric functions （real part 61 and imaginary part 62） are in agreement with the corresponding experimental results with x being between 0 and 1. The calculated zero-frequency refractive index varies greatly with x for Hg1-xCdxTe, but changes little with for In1-xGaxAs, which is consistent with the real parts of their dielectric functions. Therefore, this new approach is satisfactory to describe the electronic structures and the optical properties of the semiconductors.
Double perovskite Bi2 FeCrO6 , related with multiferroic BiFeO3 , is very interesting because of its strong ferroelectricity and high magnetic Curie temperature beyond room temperature. We investigate its electronic structure and magnetic and optical properties by using a full-potential density-functional method. Our optimization shows that it is a robust ferrimagnetic semiconductor. This nonmetallic phase is formed due to crystal field splitting and spin exchange splitting, in contrast to previous studies. Spin exchange constants and optical properties are calculated. Our Monte Carlo magnetic Curie temperature is 450 K, much higher than any previously calculated value and consistent with experimental results. Our study and analysis reveal that the main magnetic mechanism is an antiferromagnetic superexchange between Fe and Cr over the intermediate O atom. These results are useful in understanding such perovskite materials and exploring their potential applications.
