Taking vibration converter of intelligent damper for drill strings as the study object,this paper analyzes the influential factors of motion state of the ball and conducts an explicit dynamics simulation by establishing a mechanics model of vibration converter.The study basis is Newton’s laws of motion,d’alembert’s principle and hertz contact theory.And we use world coordinate system,rotating coordinate system and Frenet coordinate system to deduce kinematics equations of vibration converter.The ultimate result demonstrates that the axial velocity and maximum contact stress change with the increment of ball diameter and helix angle.It also proves the validity of our derived kinematics and mechanical models and provides a good consultant value for the design and theoretical arithmetic of vibration converter for intelligent damper of drill strings.
In an effort to develop methods of solving the issue of cuttings bed in horizontal wells, a 3-D transient model is establi- shed to simulate the distribution features and the transport mechanism of cuttings bed. The CFD calculation results show that the cut- tings at the cross-sectional area of the mutation location such as the drilling pipe connector would easily settle down to build up a cuttings bed and the transport performance of the cuttings in a horizontal well can only be improved to some extent by adjusting the working parameters without using any destruction tools for the cuttings bed, thus the issue of a cuttings bed can not be solved in general. Accordingly, a new approach to effectively prevent and actively destroy the cuttings bed by using the Cuttings Bed Impeller （CBI） is proposed, the sensitivity analysis of which is conducted to determine the optimal structural parameters and the best matched working parameters from a perspective of the wellbore cleaning. Results show that the use of the CBI produces a number of benefits, including the reduced drill string torque to avoid the stuck pipe incidents with corresponding improvement in hole quality, a shorter trip time, and less wear on the drill string, the top drive and the casing. This research offers theoretical guidelines for the design of destruction tools for the cuttings bed and for the wellbore cleaning control in the horizontal drilling.
It is difficult to determine the optimal weight on bit (WOB) of the double-driven bottomhole assembly (DD-BHA, with double stabilizers and a bent housing positive displacement motor (PDM)) which is employed during vertical and fast drilling. High WOB leads to well deviation out of control, and low WOB leads to low rate of penetration (ROP). So considering the rock physical properties, the anisotropy index function of polycrystalline diamond compact (PDC) bit was derived with the structure and cutting performance parameters of the bit, and the effect of natural hole deviation tendencies on the performance of DD-BHA resisting deviation was represented. The concept of elliptic deformation ratio was used to characterize the performance of DD-BHA resisting deviation. Eventually, a model calculating the critical WOB was established. By comparing the model predictions with the measured hole angle changes in the field, the results show that the model predictions are accurate with error less than 5.8%, which can meet the operational requirements in the projects. Furthermore, the model was adopted to justify and guide the operating conditions and parameters during drilling, which shows that the optimum WOB predicted by the model can not only control deviation but also improve ROP effectively. The model is independent on the formation characteristics of blocks, so it can be expanded widely to other oilfields.
In the current engineering methods for the gas horizontal drilling, the distribution features of cuttings bed remain an issue to be cleared, and the gas horizontal drilling is still in early stages of development. For on-site drilling, a 3-D transient model is established in this paper to simulate the distribution features and the transport mechanism of the cuttings bed, based on the gas-solid two-phase flow theory. The effects of major drilling parameters, such as the gas velocity, the drill pipe rotation, the cutting size and the eccentricity, on the cuttings transport efficiency are analyzed. The major findings of this study include that the cuttings begin to settle down and build up a fixed cuttings bed, in the most evident regions in front and behind the connector, the dominant parameter of the wellbore cleaning is the gas velocity, and, as the cutting size is increased, the thickness of the cuttings bed developed in the wellbore increases significantly. In addition, the eccentricity has some influence on the cuttings transport, and the drill pipe rotation has little effect on the cuttings transport.
