Novel porous Mn2O3 with good crystallinity was synthesized via hard-template method. Hb-Mn2O3 na-nocomposite was prepared and used for biosensor construction. The Hb-Mn2O3-Nafion modified electrode shows fast direct electron transfer and displays good electrocatalytic response to the reduction of H2O2. The response time is less than 5 s, the sensitivity is as high as 493 μA·L·mmol-1·cm-2 in a linear range of 1-100 μmol/L, and the detection limit is 0.16 μmol/L. This modified electrode also shows good stability and reproducibility. This indicates that the porous Mn2O3 provides a good matrix for enzyme immobilization and biosensor construction.
Li metal with high-energy density is considered as the most promising anode for the next-generation rechargeable Li metal batteries;however,the growth of Li dendrites seriously hinders its practical application.Herein,3D free-standing carbon nanofibers modified by lithiophilic metal particles(CNF/Me,Me=Sn,Fe,Co)are obtained in situ by the electrospinning method.Benefiting from the lithophilicity,the CNF/Me composite may effectively prevent the formation of Li dendrites in the Li metal batteries.The optimized CNF/Sn–Li composite electrode exhibits a stable cycle life of over 2350 h during Li plating/stripping.When matched with typical commercial LiFePO_(4)(LFP)cathode,the LFP//CNF/Sn–Li full cell presents a high initial discharge specific capacity of 139 mAh g^(−1)at 1 C,which remains at 146 mAh g^(−1)after 400 cycles.When another state-of-the-art commercial LiNi_(0.8)Co_(0.1)Mn_(0.1)O_(2)(NCM(811))cathode is used,the assembled NCM//CNF/Sn–Li full cell shows a large initial specific discharge capacity of 206 mAh g^(−1)at substantially enhanced 10 C,which keeps at the good capacity of 99 mAh g^(−1)after 300 cycles.These results are greatly superior to the counterparts with Li as the anodes,indicating the great potential for practical utilization of the advanced CNF/Sn–Li electrode.
