The FEM model of TiBN and TiBN/TiN coated cutting tool in milling of H13 steel w as developed. Process variables such as temperature and stress in the coating l ayer as well as in the substrate were analyzed. The efficacy of the present FEM analysis was verified by conducting controlled milling experiments on AISI H13 t o collect the relevant tool life and force data.The results show that the stress in a coated tool can significantly be reduced compared to an uncoated cutting t ool,possibly due to surface coatings improving the tribological properties of cu tting tools.Coatings with good thermal properties also help to improve the therm al behavior of cutting tool.
The effect of predeformation manner, predeformation ratio and isothermal heat-treat parameter on the non-dendrite structure of AZ61 magnesium alloy in SIMA process was studied. Under coequal heat-treat condition, the impact of the hot upsetting pre- deformation on semi-solid microstructure in SIMA process was compared with that of the cold compressive predeformation. The results indicate that non-dendrite microstructure in AZ61 magnesium alloy billets can be obtained by hot or cold upsetting predeformation in SIMA process, although their mechanisms of evolution are different. Increasing hot or cold upsetting predeformation ratio can enhance the effect and quality of the non-dendrite microstructure formed before storage energy up to saturation, but the proper isothermal temperature and holding time should be selected.
