Synthetic aperture imaging lidar is an active new imaging system, which can offer a finer azimuth resolution than the SAR system. An indoor system of synthetic aperture imaging lidar is given, which is a demonstration about synthetic aperture to image rotating objects. Firstly, the basic principle is introduced. Then, the basic method and key techniques are analyzed. After that an improved system is given with the transmitting and the receiving lens apart from each other which can eliminate the interference efficiently. Finally, the block diagram and the result of imaging system are given, which prove the validity of the system and the feasibility of the synthetic aperture techniques in optical domain.
Theoretical analysis and experimental research on the polarization properties of output light in gyro are carried out to investigate the phenomenon that the amplitude of an output voltage signal is modulated by dither bias in laser gyros consisting of totally reflecting prisms.Taking the effect of prism stress birefringence into account,an analytical formula of the output light intensity in the gyro and the relationship between the polarization parameter and the amplitude modulation of the output signal are obtained and discussed.For the first time,the polarized power value of the output light is adopted as a basis to estimate the output signal amplitude fading extent of laser gyros.Experimental results demonstrate that when the value of polarized power of output light is below 25.5%of that in ideal static case,the standard error is over 0.0337 dBm,and the displacement extent of the prism is higher than 53%of the radius of the beam waist in the gyro cavity,the amplitude modulation extent of gyro output signal can reach up to 16%,which badly influences the measurement accuracy of the laser gyro.Using this polarized power detecting measurement method can repair the gyro immediately during its fabrication process,improve the testing and production efficiency and shorten the product development cycle.
