The steady and dynamic rheological behaviors of precipitated calcium carbonate (PCC) suspension in polyethylene glycol (PEG) were investigated on a TA AR2000ex rheometer. Under steady shear consistency index K and flow exponent N of suspensions with different volume fractions were determined. The shear-thinning and the discontinuous shear-thickening behavior were observed at different constant frequencies from 10 to 100 rad/s. The relationship between the complex viscosity and the constant frequency were determined. As the volume fraction increases,flow exponent N shows a rapid increase,and it increases dramatically when the discontinuous shear-thickening takes place,while consistency index K decreases. Dynamic oscillatory shear experiments were conducted at constant strain amplitude and constant frequency,respectively. For the frequency sweep,the system shows viscous property in entire range of the frequency investigated,and the complex viscosity shows discontinuous jump at a critical frequency of 10 rad/s. For the strain sweep,on the other hand,at low strain the elastic modulus is strongly dependent on the strain,and the viscous modulus is independent of the strain. But at the critical strain point both of the moduli show an abrupt jump and the system transits from elastic to viscous at a strain of 0.1.
Rheological experiments under steady and oscillatory shear were conducted for fumed silica suspen- sions in polyethylene glycol. Under steady shear the shear-thinning and thickening response were exhibited and the flow exponent N was determined. With the increase of concentration the flow exponent N showed a rapid increase, and it increased dramatically when the discontinuous shear-thickening took place. Oscillatory shear experiments were conducted at constant frequency and constant amplitude strain, respectively. The shear-thinning and the discontinuous shear-thickening behavior were observed under different constant frequencies from 10 to 80 rad/s. The correlation between complex modulus (G*) and sweep frequency (ω) was illuminated at γ =750%. It was found that the correlation between G* and ω could be fitted by equation: G*∝ωn. The indexes in shear-thinning region and shear-thickening were determined. The indexes were similar to some extent at shear-thinning region and increased dramati- cally to a much higher value when the shear-thickening occurred,especially at higher weight fractions. The behaviors can be qualitatively explained as follows: the shear-thinning owes to decrease of viscos- ity, which results from disruption of the aggregates; the cluster theory attributes the shear-thickening to the formation of metastable, flow induced clusters, which block the system.
YANG HaiLinRUAN JianMingZOU JianPengWU QiuMeiZHOU ZhongChengZHOU ZhiHua
The shear thinning and shear thickening rheological properties of PCC/PEG suspension were investigated with the increase of oscillatory amplitude stress at different constant frequencies. The results show that the complex viscosity was initially independent of stress amplitude and obvious shear thinning occurred, then dramatic shear thickening took place after reaching the minimum viscosity. Typically, in a constant frequency of 5 rad/s, the elastic modulus, viscous modulus, and tanδ （δ is the out-of-phase angle） vs. the stress amplitude was investigated. It is found that the elastic modulus initially appeared to be independent of stress amplitude and then exhibited a rapid decrease, but the viscous modulus was independent of amplitude stress at lower amplitude stress. After reaching the minimum value the viscous modulus showed a rapid increase. On the other hand, tanδ increased from 0.6 to 92, which indicates that the transition from elastic to viscous had taken place and tanδ showed a steep increase when shear thickening occurred. Lissajous plots are shown for the dissipated energy vs. different maximum stress amplitude in the shear thinning and shear thickening regions. The relationship of dissipated energy vs. maximum stress amplitude was determined, which follows a power law. In the shear thinning region the exponent was 1.91, but it steeply increases to 3.97 in the shear thickening region.
HA/316L stainless steel(316L SS) biocomposites were prepared by hot-pressing technique. The formation of bone-like apatite on the biocomposite surfaces in simulated body fluid(SBF) was analyzed by digital pH meter,plasma emission spectrometer,scanning electron microscope(SEM) and energy dispersive X-ray energy spectrometer(EDX). The results indicate that the pH value in SBF varies slightly during the immersion. It is a dynamic process of dissolution-precipitation for the formation of apatite on the surface. With prolonging immersion time,Ca and P ion concentrations increase gradually,and then approach equilibrium. The bone-like apatite layer forms on the composites surface,which possesses benign bioactivity and favorable biocompatibility and achieves osseointegration,and can provide firm fixation between HA60/316L SS composite implants and human body bone.
