Poly(glycidylmethacrylate) (PGMA) brushes were grafted from chloromethylated polysulfone (CMPSF) mem- brane surface by surface-initiated atom transfer radical polymerization (S1-ATRP), and the grafting was followed by hydrolysis of epoxy groups in the grafting chains to improve the membrane's hydrophilie property. Fourier trans- form infrared spectroscopy (FT-IR) and X-ray photoelectron spectroscopy (XPS) measurements confirmed the suc- cessful grafting and hydrolysis of PGMA. The grafting degree of the monomer, measured by periodic acid titration and gravimetric analysis, increased linearly with the polymerization time, while the static water contact angle of the membrane grafted with PGMA or hydrolyzed PGMA linearly decreased. In comparison with the PGMA-grafted membranes, the hydrolyzed PGMA-grafted membranes possess stronger hydrophilicity as indicated by their contact angle and hydration capacity, and as a result they have an improved antifouling property. Therefore, the control of the hydrophilicity of PSF membrane could be realized through adjusting the polymerization time and transforming the functional groups in the grafting chain.
A one-step procedure to hydrophilize monodisperse poly(chloromethyl-styrene-co-divinylbenzene) beads has been presented with 2-hydroxy-3-[4-(hydroxymethyl)-1H-1,2,3-triazol-1-yl]propy1 2-methylacrylate(HTMA) as monomer by surface-initiated atom transfer radical polymerization(SI-ATRP).The length of the grafted poly(HTMA) chain was varied via controlling the ratio of HTMA to initiator on the surface of the beads.Using these grafted beads as the stationary phase in hydrophilic interaction chromatography,good separation was obtained for nucleosides in the mobile phase of acetonitrile-water.It was also found that the retention time and selectivity of solutes showed a positive relationship with the length of the grafted poly(HTMA) chain.