Euphausia pacific is an important source of natural astaxanthin.Studies were carried out to assess the extractability of astaxanthin from E.pacific using subcritical 1,1,1,2-tetrafluoroethane(R134a).To examine the effects of multiple process variables on the extraction yield,astaxanthin was extracted under various conditions of pressure(30-150 bar),temperature(303-343 K),time(10-50 min),flow rate(2-10 g min-1),moisture content(5.5%-63.61%),and particle size(0.25-0.109 mm).The results showed that the extraction yield increased with temperature,pressure,time and flow rate,but decreased with moisture content and particle size.A maximum yield of 87.74% was obtained under conditions of 100 bar,333 K,and 30 min with a flow rate of 6 g min-1 and a moisture content of 5.5%.The substantial astaxanthin yield obtained under low-pressure conditions demonstrates that subcritical R134a is a good alternative to CO 2 for extraction of astaxanthin from E.pacific.
As the key point in sex hormone analysis, sample pre-treatment technology has attracted scientists' attention all over the world, and the development trend of sample preparation forwarded to faster and more efficient technologies. Taking economic and environmental concerns into account, subcritical fluid extraction as a faster and more efficient method has stood out as a sample pre-treatment technology. This new extraction technology can overcome the shortcomings of supercritical fluid and achieve higher extraction efficiency at relatively low pressures and temperatures. In this experiment, a simple, sensitive and efficient method has been developed for the determination of diethylstilbestrol(DES) in fish tissue using subcritical 1,1,1,2-tetrafluoroethane(R134a) extraction in combination with gas chromatography-mass spectrometry(GC-MS). After extraction, freezing-lipid filtration was utilized to remove fatty co-extract. Further purification steps were performed with C_(18) and NH_2 solid phase extraction(SPE). Finally, the analyte was derived by heptafluorobutyric anhydride(HFBA), followed by GC-MS analysis. Response surface methodology(RSM) was employed to optimizing the extraction condition, and the optimized was as follows: extraction pressure, 4.3 MPa; extraction temperature, 26℃; amount of co-solvent volume, 4.7 m L. Under this condition, at a spiked level of 1, 5, 10 μg kg^(-1), the mean recovery of DES was more than 90% with relative standard deviations(RSDs) less than 10%. Finally, the developed method has been successfully used to analyzing the real samples.
