Silver nanoparticle thin films with different average particle diameters are grown on silicon substrates. Boron nitride thin films are then deposited on the silver nanoparticle interlayers by radio frequency （RF） magnetron sputtering. The boron nitride thin films are characterized by Fourier transform infrared spectra. The average particle diameters of silver nanoparticle thin films are 126.6, 78.4, and 178.8 nm. The results show that the sizes of the silver nanoparticles have effects on the intensities of infrared spectra of boron nitride thin films. An enhanced infrared absorption is detected for boron nitride thin film grown on silver nanoparticle thin film. This result is helpful to study the growth mechanism of boron nitride thin film.
Cubic boron nitride （c-BN） thin films are deposited on p-type Si wafers using radio frequency （RF） sputtering and then doped by implanting S ions. Wile implantation energy of the ions is 19 keV, and the implantation dose is between 1015 ions/cm2 and 1016 ions/cm2. The doped c-BN thin films are then annealed at a temperature between 400℃ and 800℃. The results show that the surface resistivity of doped and annealed c-BN thin films is lowered by two to three orders, and the activation energy of c-BN thin films is 0.18 eV.
A single concentrator solar cell model with a heat sink is established to simulate the thermal performance of the system by varying the number, height, and thickness of fins, the base thickness and thermal resistance of the thermal conductive adhesive. Influence disciplines of those parameters on temperatures of the solar cell and heat sink are obtained. With optimized number, height and thickness of fins, and the thickness values of base of 8, 1.4 cm, 1.5 mm, and 2 mm, the lowest temperatures of the solar cell and heat sink are 41.7 ~C and 36.3 ~C respectively. A concentrator solar cell prototype with a heat sink fabricated based on the simulation optimized structure is built. Outdoor temperatures of the prototype are tested. Temperatures of the solar cell and heat sink are stabilized with time continuing at about 37 ℃-38 ℃ and 35 ℃-36 ℃respectively, slightly lower than the simulation results because of effects of the wind and cloud. Thus the simulation model enables to predict the thermal performance of the system, and the simulation results can be a reference for designing heat sinks in the field of single concentrator solar cells.
