您的位置: 专家智库 > >

国家自然科学基金(50705094)

作品数:6 被引量:28H指数:4
相关作者:贾均红易戈文杨保平崔锦峰张晓亮更多>>
相关机构:中国科学院兰州理工大学中国科学院研究生院更多>>
发文基金:国家自然科学基金中国科学院“百人计划”更多>>
相关领域:一般工业技术电子电信化学工程理学更多>>

文献类型

  • 6篇期刊文章
  • 6篇会议论文

领域

  • 7篇一般工业技术
  • 2篇化学工程
  • 2篇机械工程
  • 2篇电子电信
  • 2篇理学
  • 1篇金属学及工艺

主题

  • 3篇图案化
  • 3篇纳米
  • 2篇性能研究
  • 2篇光学
  • 2篇STUDIE...
  • 2篇
  • 2篇ADHESI...
  • 2篇ATO
  • 2篇掺杂
  • 2篇掺杂量
  • 2篇FRICTI...
  • 1篇电阻
  • 1篇电阻率
  • 1篇亚胺
  • 1篇溶胶
  • 1篇碳纤维
  • 1篇图案
  • 1篇平均晶粒尺寸
  • 1篇紫外
  • 1篇紫外吸收

机构

  • 8篇中国科学院
  • 5篇兰州理工大学
  • 2篇中国科学院大...
  • 1篇中国科学院研...

作者

  • 5篇贾均红
  • 3篇崔锦峰
  • 3篇杨保平
  • 3篇卢永娟
  • 2篇钟小华
  • 2篇张晓亮
  • 2篇易戈文
  • 1篇姚向民
  • 1篇孟旭
  • 1篇周惠娣
  • 1篇杨士勇
  • 1篇陈淼
  • 1篇陈建敏
  • 1篇陈建升
  • 1篇梁山

传媒

  • 2篇功能材料
  • 1篇稀有金属材料...
  • 1篇无机盐工业
  • 1篇材料科学与工...
  • 1篇Partic...

年份

  • 3篇2012
  • 3篇2011
  • 2篇2009
  • 4篇2008
6 条 记 录,以下是 1-10
排序方式:
Adhesion and Friction Studies of Micro-patterned Surfaces using Atomic Force Microscopy with Colloidal Probe
<正>Surface patterns play an important role in affecting the adhesive force and friction force in micro/nano-el...
Xiaoliang Zhang~(1
文献传递
纳米金颗粒在氨基硅烷自组装薄膜上的组装及其摩擦性能研究
利用自组装技术,在3-氨基丙基-三甲氧基硅烷(APS)自组装薄膜表面组装纳米金颗粒,通过控制不同组装时间控制纳米金颗粒堆积密度,并利用原子力显微镜(AFM)和X-射线光电子能谱(XPS)进行形貌和成分表征;利用UMT摩擦...
姚向民崔锦峰杨保平贾均红
关键词:纳米金颗粒
文献传递
化学浴法Cu2S纳米晶薄膜的制备及其光学特性研究被引量:5
2008年
利用化学浴沉积法,以EDTA为络合剂,CuSO4.5H2O和Na2S2O3为前驱体溶液制备了硫化亚铜纳米薄膜,用FESEM、XRD、光学显微镜研究了前驱体浓度、络合剂的浓度、溶液的pH值、反应温度等因素对硫化亚铜纳米薄膜的表面形貌、晶粒大小与晶体结构的影响。结果表明,在最佳的生长条件下可以制备晶粒匀一、结构致密的硫化亚铜纳米薄膜,紫外可见吸收光谱表明硫化亚铜薄膜具有一定的透光性,并对红外光有很好屏蔽的作用。
卢永娟梁山陈淼贾均红
关键词:紫外吸收
紫外光刻法制备图案化的硫化铜薄膜及其光学性能的研究
本文利用紫外光光刻技术结合化学浴沉积的方法,以EDTA为络合剂,CuSO·5HO和Na SO为前驱体溶液,在70℃下选择性的沉积硫化铜纳米颗粒,制备了具有图案化结构的硫化铜纳米薄膜。通过SEM、表面三维轮廓仪、XRD等对...
卢永娟贾均红
关键词:光学性能
文献传递
纤维增强聚酰亚胺复合材料的摩擦学行为被引量:10
2008年
本文研究了碳纤维、玻璃纤维及石英纤维增强的PI复合材料在干摩擦和水环境下的摩擦磨损行为。研究表明,碳纤维增强PI复合材料在两种摩擦条件下的摩擦系数和磨损率都随碳纤维含量的增加而不断降低。而玻璃纤维和石英纤维增强PI复合材料的摩擦系数和磨损率则随纤维含量的增加而增大。材料的磨损均以塑性变形、微观破裂及破碎为主导,相同纤维种类和含量增强PI复合材料在水环境下的磨损率均较干摩擦下的低,这主要归因于摩擦副表面吸附或存留的水分的边界润滑作用。
贾均红陈建升陈建敏周惠娣杨士勇
关键词:聚酰亚胺碳纤维复合材料
Effect of calcining temperature and time on the characteristics of Sb-doped SnO_2 nanoparticles synthesized by the sol-gel method被引量:8
2012年
Spherical Sb-doped SnO2 (ATO) nanoparticles were synthesized by the sol-gel route, employing SnCl4·5H2O and SbCl3 as precursors in an ethanol solution. The influences of the calcining temperature and calcining time on the crystallite size, crystallinity, lattice parameters, lattice distortion ratio and the resistivity of the ATO nanoparticles were synthetically investigated. The results suggested that the ATO nanoparticles were crystallized in a tetragonal cassiterite structure of SnO2 with a highly (110)- plane-preferred orientation. The calcining temperature had a dominating effect on the crystallite size, crystallinity, lattice distortion ratios and resistivity of the ATO. As the calcining temperature increased, the average crystallite size increased, the crystallinity was promoted accompanied by a decrease in the lattice distortion ratio and a corresponding decrease in the resistivity of the ATO. X-ray diffraction (XRD) and Fourier transform infrared spectrophotometer (FTIR) analysis revealed that Sb ions could not entirely supplant the Sn ions in the SnO2 lattice for a calcining time of less than 0.5 h, even at a calcining temper- ature of 1000°C. The ATO nanoparticles calcined at 1000°C for 3.0h possessed the lowest resistivity of 10.18Ωcm.
Xiaohua ZhongBaoping YangXiaoliang ZhangJunhong JiaGewen Yi
关键词:掺锑二氧化锡煅烧温度纳米溶胶傅立叶变换红外光谱仪平均晶粒尺寸
Adhesion and Friction Studies of Microhole-patterned Surfaces using AFM with Colloidal Tip
<正>This paper presents the results of adhesion and friction on the microhole-patterned surfaces.The microhole-...
Xiaoliang Zhang~(1
关键词:ADHESIONFRICTIONAFM
文献传递
锑掺杂量对ATO薄膜结构及光、电性能的影响被引量:2
2012年
以四氯化锡和三氯化锑为主要原料,采用溶胶-凝胶法制备了不同锑掺杂量的纳米锑掺杂二氧化锡(ATO)薄膜。分别利用XRD、FESEM、紫外可见分光光度计和四探针电阻仪对晶体结构、薄膜形貌、光透过率和薄膜方块电阻进行表征,考察锑掺杂量对ATO薄膜晶体结构、晶粒尺寸、光透过率和导电性能的影响。结果表明:所制备的ATO薄膜为(110)面择优取向的四方相锡石结构,晶粒尺寸小于26 nm,当锑掺杂量为10%(物质的量分数)时,ATO薄膜具有最小的方块电阻(60.1Ω/□),可见光透过率大于85%。
杨保平钟小华张晓亮崔锦峰贾均红易戈文
关键词:方块电阻
CdS纳米薄膜的制备及其图案化
本文利用化学浴沉积法,以N(CHCHOH)为络合剂,Cd(CHCOO)·2HO和HNCSNH为前驱体溶液制备了六方纤维锌矿型的CdS纳米薄膜,利用冷场发射扫描电镜(FESEM)、X-射线衍射(XRD)考察了前驱体浓度、络...
孟旭杨保平崔锦峰卢永娟贾均红
文献传递
Fabrication of Transparent Superhydrophilic TiO_2 Nanofilm without UV-irradiation
2012年
A transparent phase-pure anatase TiO2 nanofilm was prepared through magnetron sputtering method,and a subsequent annealing treatment awarded it the superhydrophilic characteristic.To make clear the mechanism of the heat-induced superhydrophilicity,the chemical composition and surface morphology of the film were investigated in detail and compared before and after the annealing treatment mainly by field emission scanning electron microscopy(FESEM),X-ray diffraction method(XRD),Raman spectroscopy,and X-ray photoelectron spectroscope(XPS).The results suggest that the probable mechanism is in accordance with the UV-induced mechanism,where the heat-induced surface oxygen vacancies and hydroxyl radicals play important roles for achieving the superhydrophilicity.
Du Wen1,2,Ye Yinping1,Li Hongxuan1,Zhao Fei1,2,Ji Li1,Quan Weilong1,2,Chen Jianmin1,Zhou Huidi1 1 State Key Laboratory of Solid Lubrication,Lanzhou Institute of Chemical Physics,Chinese Academy of Sciences,Lanzhou 730000,China 2 Graduate University of Chinese Academy of Science,Beijing 100049,China
关键词:SUPERHYDROPHILICITYTRANSPARENTNANOFILMS
共2页<12>
聚类工具0