Natural rubber grafted maleic anhydride （NR-g-MAH） was synthesized by mixing maleic anhydride （MAH） and natural rubber （NR） in solid state in a torque rheometer using dicurnyl peroxide （DCP） as initiator. Then the self-prepared NR-g-MAH was used as a compatibilizer in the natural rubber/short nylon fiber composites. Both the fimctionalization of NR with MAH and the reaction between the modified rubber and the nylon fiber were confirmed by Fourier transform infrared spectroscopy （FTIR）. Composites with different nylon short fiber loadings （0, 5, 10, 15 and 20 phr） were compounded on a two-roll mill, and the effects of the NR-g-MAH on the tensile and thermal properties, fiber-rubber interaction, as well as the morphology of the natural rubber/short nylon fiber composites were investigated. At equal fiber loading, the NR-g-MAH compatibilized NR/short nylon fiber composites showed improved tensile properties, especially the tensile modulus at 100% strain which was about 1.5 times that of the corresponding un-compatibilized ones. The equilibrium swelling tests proved that the incorporation of NR-g-MAH increased the interaction between the nylon fibers and the NR matrix. The crosslink density measured with NMR techniques showed that the NR-g-MAH compatiblized composites had lower total crosslink density. The glass transition temperatures of the compatibilized composites were about 1 K higher than that of the corresponding un-compabilized ones. Morphology analysis of the NR/short nylon fiber composites confirmed NR-g-MAH improved interfacial bonding between the NR matrix and the nylon fibers. All these results signified that the NR-g-MAH could act as a good compatilizer of NR/short nylon fiber composites and had a potential for wide use considering its easy to be prepared and compounded with the composites.
This work focused on the effect of nanocrystalline cellulose （NCC） on the curing characteristics, aging resistance and thermal stability of natural rubber （NR） reinforced with carbon black （CB）. Sharing the same fillers loading of 45 parts per hundred rubber （phr）, NR/NCC/CB composites with different NCC/CB ratios （i.e. 0/45, 5/40, 10/35, 15/30, 20/25 phr） were prepared and analyzed. Resorcinol and hexamethylene tetramine （RH）, acting as the modifier in NR/NCC interface, was also discussed for its influence. The result showed that an relatively higher ratio of NCC/CB led to a lower torque, a shorter cure time （Tg0）, a slightly longer scorch time （Ti0） and a bigger vulcanization rate constant （K）. This tendency suggested that the existence of NCC accelerated the vulcanization process. Additionally, modified by RH, NR/NCC/CB compounds exhibited a short T10 and a elevated torque. And a moderate RH content would lower the E of vulcanization. A 10 phr substitute of CB by NCC can help to improve aging resistance in terms of mechanical properties. In a high temperature aging condition, composites with 10 phr NCC also performed the highest storage modulus （G＇） among composites tested. A moderate NCC content contributed to the best retention of G＇ after high temperature aging, so did the incorporation of RH. With the partial replacement of CB by NCC, the temperature of 5% weight-lose had a slight drop and the apparent crosslink density showed a decrease. Thanks to the interaction of RH with both NR and NCC, composites showed an improvement in apparent crosslink density after modified by RH.
