Objective： To compare the regulatory effects of electro-acupuncture （EA） at acupoints Zusanli （ST36） and Hegu （LI4） on the visceral hyper-sensitivity in the rat model of irritable bowel syndrome （IBS）, and to explore the acting targets and specialty of acupoints. Methods： Except 8 rats of the normal control group, the rest 32 rats were prepared to set up the IBS models. IBS animal model was prepared by enema with acetic acid. Model rats were divided into three groups. Except for rats in the model group for control, those in the other two groups were treated 20 min by EA on ST36 （EA-ST36） and LI4 （EA-LI4） respectively for 2 weeks to observe the effect on behavior response of viscera sensitivity. The changes of neuropepUde （NPY）, the somatostatin （SS） levels in blood and tissues of brain and intestine were monitored as well. Results： The volume thresholds for abdomen uplifting and beck hunching were obviously increased after EA-ST36 （P〈0.05）, but showed insignificant change after EA-LI4. NPY contents lowered and SS contents increased in model rats; both EA-ST36 and EA-LI4 could raise the level of thalamic NPY （P〈0.01 and P〈0.05, respectively）, but showed insignificant effects on NPY in colonic tissue. As for SS content, its colonic level could be reduced by EA-S36 and EA-LI4 （P〈0.01 and P〈0.05, respectively）, however, its blood level was affected only by EA-ST36 （P〈0.05）. Conclusions： EA-ST36 or EA-LI4 could regulate the NPY in thalamus and SS in colonic tissue, the former could affect blood level of SS as well. It is deemed that NPY and SS may be the key substances for regulating the action of acupuncture in the braln-intastinal axis; their different levels could be regarded as an indicator for the functional differenca between the acupoints.
According to the chemical and phase composition of the nickel-copper-iron matte containing precious metals and the progress in enrichment of precious metals from the nickel-copper-iron matte containing precious metals at home and abroad, this paper put forward the process route of enrichment of precious metals and selectively leaching of base metals from the nickel-copper-iron matte by sulfuric acid and sodium hypochlorite. The effects of particle size, leaching temperature, leaching time, amount of sulfuric acid and sodium hypochlorite on the leaching rate of nickel, cobalt, copper and iron are mainly discussed. The results show that raw material particle size has significantly effects on the leaching rate of base metals, high leaching rate of base metals and enrichment of precious metals are obtained with the suitable particle size. Through the experiments, the reasonable experiment parameters and conditions were determined as fellows: particle size of-200 to +250 mesh, leaching temperature 95℃ , leaching time 5 h, sulfuric acid concentration 30%, adding amount of sodium hypochlorite 3 times of matte weight. Under these experiment parameters and conditions, the leaching rate of nickel, cobalt, copper and iron were 97.39%, 96.24%, 98.30% and 99.01%, respectively. The content of nickel, cobalt, copper, iron in the leaching residues was 8.15%, 0.23%, 1.40% and 0.24%, respectively. The content of Pt, Pd, Au, Ag and Rh in the leaching residues was 247 g/t, 521 g/t, 112 g/t, 494 g/t and 24 g/t, respectively. The content of Pt, Pd, Au, Ag and Rh in the leaching solution was <0.0005 g/L, 0.0023 g/L, 0.0007 g/L, <0.0005 g/L and 0.00017 g/L, respectively. This process has advantages as follows: a small investment, simple technology, high enrichment efficiency.
FAN XingxiangLIU YangDONG HaigangFU GuangqiangWU YuedongZHAO JiachunWU Xiaofeng
On the basis of reviewing the progress in the high efficient enrichment from secondary resources of low grade precious metals at home and abroad, a process route of the high efficient enrichment precious metals from secondary resources of low-grade metals by adding iron oxide as the trapping agent, reducing agent, additive, mixing uniformly and grinding, pelletizing, reduction, grinding and separation, and selectively acid leaching iron has been put forward in this paper. The experiments of reduction, grinding and separation, and selectively acid leaching iron were carried out mainly. Under the decided experiment parameters and conditions, iron generated during the reduction can trap precious metals during reduction, high active alloy powders were obtained from the reduced products by grinding and separation, the concentration of precious metals was obtained by acid leaching high active alloy powders. The better enrichment effect was obtained by adopting the technical route of processing. Other low grade noble metal materials and enrichment ratio of precious metals from the materials to acid products was high through acid leaching. This process has the advantages of simple process, environmental-friendly, strong adaptability of raw materials, high concentration ratio, which was regarded as a kind of the general efficient enrichment technology of low grade precious metal materials.
FAN XingxiangFU GuangqiangDONG HaigangWU YuedongLIU YangZHAO JiachunWU XiaofengLI BojieTONG Weifeng
Aiming to the low-grade rhodium-containing waste materials, a new process was proposed to enrich and activate rhodium by smelting using iron oxide as a trapping agent and activator. A rhodium concentrate was obtained by the separation of base metals and precious metals. The concentrate was reacted with dilute aqua regia to obtain rhodium solution. The factors influencing the enrichment and activation effects were discussed in this paper. The results showed that the dissolution rate is greater than 99% under the optimum conditions. In this process, the activation of rhodium was finished in the enrichment process. The iron oxide is both a trapping agent and activator, which simplifies the process and reduce the cost.
Phosphorus is a key element and plays an important role in global biogeochemical cycles. The evolution of sedimentary environment is also influenced by phosphorus concentrations and fractions as well as phosphate sorption characteristics of the marine sediments. The geochemical characteristics of phosphorus and their environmental records were presented in Jiaozhou Bay sediments. Profiles of different forms of phosphorus were measured as well as the roles and vertical distributions of phosphorus forms in response to sedimentary environment changes were investigated. The results showed that inorganic phosphorus （IP） was the major fraction of total phosphorus （TP）; phosphorus which is bound to calcium, iron and occluded phosphorus, as well as the exchangeable phosphorus were the main forms of IP, especially calcium - phosphorus, including detrital carbonate-bound phosphorus （Det- P） and authigenic apatite-bound phosphorus （ACa- P）, are the uppermost constituent of IP in Jiaozhou Bay sediments. Moreover, the lead-210 chronology technology was employed to estimate how much phosphorus was buried ultimately in sediments. And the research showed that the impacts of human activities have increased remarkably in recent years especially between the 1980s and 2000. According to research, the development of Jiaozhou Bay environment in the past hundred years can be divided into three stages ： （ 1 ） before the 1980s characterized by the relatively low sedimentation rate, weak land-derived phosphorus inputs and low anthropogenic impacts; （2） from the 1980s to around 2000, accelerating in the 1990s, during which high sedimentation rates, high phosphorus abundance and burial fluxes due to the severe human activities impacted on the whole environmental system ; （ 3 ） after 2000, the period of the improvement of environment, the whole system has been improved including the decreasing sedimentation rates, concentration and the burial fluxes of phosphorus.
DAI JicuiSONG JinmingLI XuegangYUAN HuamaoZHENG GuoxiaLI Ning
Different methods of measuring a propagating laser beam quality are summarized.The disadvantages in traditional way in measuring a laser beam quality is analyzed and the insufficiencies of the Shack-Hartmannin method which is commonly using wave front technique at present is pointed out.Finally,the transmission intensity equation based(TIE-based)measuring way in a laser beam quality evaluation and the corresponding advantages are discussed,which is believed to be a deve-l oping trend in laser beam evaluation.
In this paper,an approach of square coordinate transformation is proposed to approximate the spectral abscissa for continuous-time switched linear systems.By applying elementary transformations iteratively,a series of minimums of least μ1 matrix set measures are obtained,which are utilized to approximate the spectral abscissa of the switched system.The approach is developed into tractable numerical algorithms that provide upper bound estimates of the spectral abscissa.Numerical simulations show the effectiveness of the proposed method.
To calibrate the phase retardance of a Liquid crystal variable retarder(LCVR),its birefringence dispersion characteristic was analyzed,and the Support vector machines(SVM) algorithm was adopted to establish the prediction model.The obtained SVM decision function was used as a part of LCVR phase retardance,which was generated by the driving voltage.The experimental verification was carried out with a 568 nm laser.The results show that the deviation of the experimental value and the theoretical value is about 0.0061λ.SVM method could be used as an effective method for LCVR phase retardance characteristic calibration.
